2004 Toyota Tundra Parking Brake Adjustment

Parking Brake Cable are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty.

2004 toyota tundra parking brake adjustment. If there is still a problem pull the drum and inspect the linings for excessive. 236-horsepower 40L V6 5-speed automatic RWD. The Toyota dealer told me that the rear brakes needed to be adjusted every 10000 miles to keep the brakes and parking brake in adjustment.

There are a few other Parking Brake Adjustment Threads on here in the 1st Gen Section. It works the same on a Sienna as you described at least on the earlier models. The parking brake cable usually also has some adjustment points that allow the parking brake cable to be adjusted.

Replacing the parking brake cable can. Toyota Tundra 2004 Parking Brake Cable by Dorman. Gently lock the vice grip on the front end of the threaded adjuster rod to keep it from turning and break the lock nut free on the other end.

If you think they are not adjusted try backing up and applying the brakes every few feet. Shop OEM 2004 Toyota Part 464100C010 46410-0C010 464100C011. Seek those out and follow the directions per the Factory Service Manual Guide.

Attached are two nuts that adjust the hand parking brake. Its pretty straightforward and shouldnt take you more than a few hours. Test your adjustment and pull up on the hand parking brake lever.

Sounds like its time to adjust the parking brake system. The rear shoes must be adjusted first if they are adjusted then you can adjust the cable the adjustment for the cable is done at the pedal there is an adjusting nut and a lock nut first back off the locking nut then turn the adjusting nut a few turns and check the brake it shoud have 6 to 9 clicks before it stops once the cable is adjusted tighten the lock nut I will post a diagram below that shows this adjusterTim. Use your pliers to turn the nuts around the two rods sticking out the back of the hand parking brake.