2001 Toyota Tundra Ignition Switch Removal

Slide the cylinder into the lock housing until the stop tab engages the hole in the lock.

2001 toyota tundra ignition switch removal. No issues or warnings before it went out. Switch out of the lock position into starting my truck. Ignition problems with a 2000 Tundra.

Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. Press the release bottom with this screwdriver as you pull the lock cylinder straight out. May apply to differnt Toyota vehicles as well2010 Toyota Tundra SR5.

Rotate ignition switch lock cylinder 11582 to the RUN position. USUALLY though the problem is caused by pressure of the steering wheel lock bar on the cylinder. 2006 toyota tundra the ignition switch is sticking and at present is stuck thus not allowing the truck to start.

Detach the illumination ring by pulling out the plastic pin on the side. To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. How to video on Toyota Tundra Key lock cylinder removal.

I bought one for 17 used at the Pick-n-Pull. I am having intermitted. Make sure both the lock cylinder and column lock are in the ACC position.

Peel back flap over the ignition and pull the bezel straight toward the backside of wheel. Customer was having trouble with the key not working in Ignition lock on a 2001 Toyota Tundra. T he ignition on my 2002 Toyota Tacoma 4x4 TRD locked up after I parked with the left front wheel pushed against a curb vehicle at 40 degree angle to the curb.