Toyota Tundra Air Injection Pump Bypass

Toyota Tundra 2007 with engine check light on also the 4LO.

Toyota tundra air injection pump bypass. I purchased my third Toyota 4X4 a Tundra Double Cab in July 2007. The module itself is wired into the mass air flow MAF sensor harness and it gives your Tundras engine computer the impression that the air injection system isnt needed. I checked it with the code reader at a local shop and.

A good place to start would be the beginning of this thread. If you have a 2005-2008 Toyota Tundra 47L with a code P2440 p2441 P2442 andor P2443 you may have a faulty air injection pump valve andor leaking supply. In this video I t.

Toyota Tundra 2007 with engine check light on also the 4LO is flashingMechanic saysXXXXXfunctions normally. 2 air switching valves are controlled by two vacuum switching valves and only uses a single pressure sensor under the intake. Fits Tundra 2011 - 2014 Air Injection System Air Pump - Repair or Replace.

Most questions about the bypass kit have been answered several. P2445 is an air Pump Stuck Off failure which is a associated with the Air injection driver. Hello I would like to have some feedback on these bypass kits.

These kits offer a. Toyota 47L Air Induction Pump Bypass Kit Exhaust Port Plates - NO CUTTING. The dealer charges upwards of 4000 to change an air pump this kit is only 400 and the car would still pass inspeciton.

A failed air injection pump or secondary air pump will often have no noticeable symptoms beyond a check engine light but it does cause your Toyota Tundra to operate inefficiently and produce. This video will help you install the Air Induction Pump Bypass Module in a Toyota Sequoia or Tundra that can be purchased on Ebay. My 2007 Toyota Tundra went into Limp Mode when multiple dash warning lights came on.