2010 Toyota Tundra Oil Light Reset

Toyota Tundra Oil Maint Required Message Reset Procedure for Model Years 2005-2015.

2010 toyota tundra oil light reset. Then hold the trip reset button while turning the key back to the ON position. If your vehicle has an ignition button press the STARTSTOP button two times without step on the brake pedal. Oil Viscosity and Capacity The 4 liter engine holds approximately 48 quarts 45.

This video shows you how to reset the Maintenance Light on a 2010 Toyota Tundra. Not sure if this has been asked if so I cant seem to find it. Oil change wont change anything if level is already good.

The procedure is applicable to the second-generation Toyota Tundra pickup truck 2007 to 2010. In the future you also can ask your Toyota dealer to reset the light after changing the oil. When replacing sensors and performing maintenance on a Toyota Tundra the engine control unit may not turn the indicator light off.

Continue holding the Trip Reset button down until the odometer reading displays 000000 for one second. It may ruin the engine. With vehicle ignition switched to ON position make sure odometer is showing Tripmeter A then turn the ignition switch to OFF position.

This is how you turn off the maintenance light on a Prius. While holding down the trip meter reset knob turn the ignition to run one position before starting engine. Youll see the odometer flashing 5 lines then 4 then 3 2 and 1 until all the lines are gone.

Go down and select the VEHICLE SETTINGS. Do not drive the vehicle with the warning light oneven for one block. Push and hold down the ODO button and push the Power button twice with your foot off the brake.