2006 Toyota Tundra Evap Canister Location
They said the next step was the canister.
2006 toyota tundra evap canister location. One of the most common trouble codes with the Toyota Tundra is the P0455 codeThis trouble code references a number that is given to you when you plug your Tundra into a OBD2 scanner and has to do with the emissions system. P0446 TOYOTA code description The Evaporative System canister vent control valve is located on the EVAP canister and is used to seal the canister ventThis solenoid valve responds to signals from the Engine Control Module When the ECM sends an ON signal the coil in the solenoid valve is energized. Visually inspected all hoses all the way back to the fuel tank and they.
I was confused but I got over it. 2004-2006 Toyota Tundra Canister Assy Charcoal Part Number. Toyota is having a lot of problems with failures in their EVAP systems.
VALVE EVAP SERVICE PORT. This is the solenoid that opens to allow air into the charcoal canister during a purge cycle. When it goes bad it typically causes issues with the vehicles idle speed.
P0455 Indicates that there is a large leak in the evaporative emission control system EVAP. I show you the location of the EVAP canister. Genuine Toyota 77310-48020 Fuel Tank Cap Assembly.
3 tank fills were normal then it started filling slow again but not stupid slow like before. But then it sat for a few months and the next time I filled it it was normal. 20062009 Toyota RAV4 Factory Service Bulletin OBDII Code P2401 The service bulletin recommends replacing the EVAP Charcoal Canister Assembly to repair the problem.
Anyway they want 500 to replace the canister. Genuine Toyota Charcoal Vapor Canister Assembly. When there is a small leak in the Toyota Tundras EVAP system it will throw the P0456 OBDII Code.