2006 Toyota Tundra Brake Bleeding Procedure

You will need two people to bleed the brakes unless you have fancy equipment.

2006 toyota tundra brake bleeding procedure. It worked good on the tundra it was removed from. It may be possible to crack each hard pipe connection at the module then slowly press the brake pedal to expel the air from that connection similar to bleeding caliper but without further investigation I would not mess with the module without knowing for sure. Next time you do brakes do this instead to avoid this issue all together.

This article applies to the Toyota Tacoma 1996-2015. If any work is done on the brake system or if air in the brake lines is suspected bleed the air from the system. But I can not get it bled.

1 With the engine off step on the brake pedal several times to relieve the brake booster of vacuum. Toyota Tacoma Upgrading Brakes to Tundra 231mm Tundra 231mm Brake Upgrade Give your truck some real stopping power. Lines on the reservoir.

- the old school method of two people is still hard to beat. Once you sign in follow these instructions to access our Repair Guides. Pump the brakes for a few minutes with the Tundras engine running check the fluid level from time to time always put the lid on the master cylinder you dont want more air entering the system.

That still presents the possibility of air being trapped in system - BEST is vacuum or pressure bleeding. Connect clear type hose to brake bleeder and the other end into the jar of fluid. You know they have stroked out the travel of the master cylinder.

Upgrade to Tundra brakes. Asked by Taipan1001 in Farmington AR on. If there is a weak link in the brake and ABS system it would be the brake fluid.