2000 Toyota Tundra Rear Axle Removal

Nitro Gear Axle take the steps necessary to.

2000 toyota tundra rear axle removal. The lines are directly above the axle. It seems too difficult to find a clean assemblyhousing with that exact configuration but I see. 2000 Tundra Limited 4x4 1100 Build 32 lift visor 2857516 eibach pro-truck Cvj axles custom lighting.

Httpsamznto2RK71GiOEM REAR AXLE SEAL. They had rigged something to the hydraulic press and put some unbelievable. I pulled the rear axles out today to be sent off and have new bearings pressed in and replace the tube seals.

14mm wrench Second remove the 2 brake lines from the drums. Unfortunately for the truck I live in New England. Last year I thought its was shoes and wheel cylinder replaced those but issues continued.

Hello everyone Im the proud owner of an 03 Tacoma 4x4. You will loosen the lug bolts raise and support the truck remove the wheel then remove the brake drum then remove the 4 bolts that hold the backing plate onto the rear axle tube remove the brake line from the wheel cylinder disconnect the e-brake cable and then pull the axle out. Also you should replace the seals for the axles of if you are changing the bearings.

Common causes of axle seal failure are plugged differential breathers or worn wheel bearings. When a rear axle seal goes bad its typically noticeable by gear oil leaking all over a rear wheel and it may get into the brake drum and reduce rear brake feel. They cant seem to get the bearing and housing to bust loose from the axle.

Nitro Gear and Axle strives to provide the highest quality differential components available. Next remove the 4 17mm nuts that hold the axle and bearing assembly to the axle tube. I recomend draining and changing your rear differential fluid too because if the fluid by run out of axle housing.