2000 Toyota Tundra Change Ignition Switch

This is a VERY difficult job and is not recommended to those who do not have sufficient automotive experience.

2000 toyota tundra change ignition switch. Press the release bottom with this screwdriver as you pull the lock cylinder straight out. When not replaced vehicle could experience. Please see your Owners Manual for further details and important safety informati.

Make sure both the lock cylinder and column lock are in the ACC position. Problems in getting anyone of my keys to turn the ignition. You must remove the intake plenum to get to starter to fix or replace starterIf you are going to replace starter make sure the battery terminals on starter are in the correct placement for cables.

To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. If not they will replace the cylinder at the cost of 150 or so. Secure the switch with its screws.

Remove unlock warning switch cable transponder key amplifier and then unlock warning switch. Slide the cylinder into the lock housing until the stop tab engages the hole in the. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.

ON the replacement starter I purchased the terminals were backwardsI returned the starter for refund and ended replaceing brushes on the original. You need to replace the starter solenoid contacts or the starter itself. Or check for ohms.

1-2 of 2 Results Filter Sort Duralast Ignition Switch LS905 Part. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. He took the key to a locksmith and he said the problem is with Toyota cylinder.