2000 Toyota Tundra 4.7 Throttle Body Cleaning

Tighten up your throttle cable tension once everything is hooked back up mine needed it due to years of never being done. Remove hoses running to intake. Pull upper intake off tb and set aside.

2014 toyota tundra blacked out 2014 toyota tundra crewmax 4x4 2014 toyota tundra oem parts 2014 toyota tundra gas tank capacity 2014 toyota tundra lug nut torque 2014 toyota tundra engine 57 l v8 2014 toyota tundra lug nut torque specs 2014 toyota tundra bolt pattern

Toyota Tundra Throttle Body Removal Cleaning Youtube

Diy Clean Or Replace The Throttle Actuator On Toyota Tundra 2000 2006 Reset Service Light Reset Oil Life Maintenance Light Reset

2000 Toyota Tundra Throttle Body Replacement Youtube

2021 Toyota Tundra News And Information Conceptcarz Com

Fuel Filter Replacement Toyota Tundra Install Remove Replace Gas Youtube

Mt Then And Now 2000 2014 Toyota Tundra

Read more JOHN aka Eauto.

2000 toyota tundra 4.7 throttle body cleaning. Run the engine for 4 - 5 minutes and then snap the throttle several times to dislodge any carbon that may remain in the system. It had 2 codes that helped me replac. This is how to properly service your throttle body actuator and plate on a 47L V8 Toyota Tundra between the years of 2000-2006.

You have a bad APPS Accelerator Pedal Position Sensor. Remember where everything plugs in and get the baby sparklin Throttle body cleaner. Pull tb out enough to Unclip coolant lines.

When it runs I can push the accelerator half way down and nothing. Disconnect the TB and give a cleaning plug the coolant lines to stop leakage will need to make or buy a new gasket. Replaced TPS and now cannot get it to run right.

I replaced the Throttle Body while chasing down a P0121. Road test the vehicle to verify normal operation. Remove 4 10mm bolts holding tb to manifold.

After replacing the TB is was 1150-1200. Then it will accelerate but nothing during 1st half of pedal. Using the same 10mm socket remove the nut attaching the air conditioning line to the intake tube of the.

Open the hood and remove the two 10mm nuts holding the engine covering. Before I replaced the throttle body the truck idled at 760 or so. Now it idles between 1225 and 1400.